Products: single-rod vibrating level switch is a tuning fork level switch in one, it is not afraid not afraid of hanging material impact, no clip material problems, and higher sensitivity. Its cylindrical single measuring rod structure determines its wider adaptability industrial site. Single rod vibrating level switches use a tuning fork "resonance" principle, resulting in driving the piezoelectric element vibration, all of the material when it is surrounded by a sharp reduction in the vibration amplitude was only around the probe, resulting in switching. Features: (1) circular smooth single-rod probe, can effectively prevent the clip material and adhesive material, in the large hanging material, still stable sensitivity constant. (2) the impact of physical properties are not measured, without adjustment after installation, you can put to use stable (3) using a piezoelectric element built into the rod and thick wall stainless steel probe, absorber tubes only 9mm long (the same ratio Shortest) (4) according to the measurement of different objects, adjust measurement sensitivity (high L, M low H), select the measured specific gravity different hierarchical level or powder bits (5) using the high-capacity electrical connection 15A relay switch, can be implemented directly on the motor control (6) compared with the resistance spin: no moving parts, rugged wear and material impact probe, adjustable sensitivity (7) compared with capacitive: not influence the dielectric constant, surface self-cleaning (8) easy to use, durable, after installing the application of transportation equipment without calibration material flow detection solid-liquid interface detection powders, pellets, bulk solid material level detection brief parameters: ● Technical parameters Power: 220V / 105V / 24V AC / DC Power consumption: 2.5W frequency: 280Hz relay contacts: normally open and normally closed junction AC250V / DC30V 5A Electrical connection: M20 × 1.5 (￠ 8- ￠ 10 cable) delay time: measured (vibration stops) 0.5 seconds, the recovery (stop vibration) 1 to 2 seconds Working temperature: probe unit / -30 C ~ + 200 C. substrate unit / -30 C ~ + 70 C. Switch Function: NO normally open and normally closed NC, common COM Power:. 220VAC / 105VAC / 24VDC frequency: 280HZ contact capacity: 250VAC / 30VDC 5A SPDT Electrical Interface: M20 * 1.5 Delay Time: measured (vibration stops) 0.5 seconds, recovery (stop vibration) 1-2 seconds of work Temperature: probe part: -30 ℃ -200 ℃ substrate unit: -30 ℃ -70 ℃